Table of Contents
Advertisement
8. Turn power switch ON.
9. Close gun air valve.
10. Point gun into waste bucket and pull trigger to pump
water through the system. Continue to trigger gun
until material hopper is empty.
WARNING
page 3
11. Install burp guard.
12. Add pre-mixed texture mix
to material hopper. See
Mixing Material, page 9.
13. Continue to trigger gun and spray into waste bucket
until a steady stream of material sprays out of gun.
14. Release trigger. To
achieve uniform
spray pattern, adjust
air valve and flow
adjustment nut on
gun. If you do not
achieve the desired
pattern, change nozzles, page 10.
Fluid flow will be restricted if the material hose is
kinked.
309863A
ti2453
ti3158a
TI2698a
Hopper Attachment
ti2446a
The Hose Plug must be
securely fastened to
bottom of gun when
using the Touch Up
Hopper. Gun Plug must
be removed from top of
gun.
1. Connect air hose to sprayer.
2. Connect air hose to gun.
3. Clip material hose to
air hose.
4. Slide hopper on top of
gun, and tighten clamp.
5. Install spray nozzle.
Page 10.
6. Fill hopper attach-
ment with pre-mixed
texture. See Mixing
Material, page 9.
Setup
ti2699a
ti2721a
ti3528a
ti3529a
7
Advertisement
Table of Contents
