Graco Magnum TexFinish 246186 Operation page 3

Rental interior texture sprayer
Hide thumbs Also See for Magnum TexFinish 246186:
Table of Contents

Advertisement

Electric Shock Hazard
To reduce the risk of electric shock:
Be sure sprayer is adequately grounded through electrical outlet.
Use only 3-wire, extension cords.
Make sure ground prongs are intact on sprayer and extension cords. Improper installation of ground-
ing plug will result in a risk of electrical shock, fire or explosion that could cause serious injury or
death.
Do not operate with cover removed.
Turn off sprayer. Follow Pressure Relief Procedure, page 5, and unplug unit, before removing any
parts.
Pressurized Equipment Hazard
Fluid from gun, leaks or ruptured components can splash in the eyes or on skin and cause serious injury.
Follow Pressure Relief Procedure, page 5 when you stop spraying and before cleaning, checking
or servicing.
Do not point spray gun at anyone; put hand, fingers or rag over nozzle, or stop or deflect leaks with
your hand, body, glove, or rag.
Wear protective clothing, gloves, and eyewear.
Cleaning Solvent Hazard with Plastic Parts
Use only compatible water-based solvents to clean plastic structural or pressure-containing parts. Many
solvents can degrade plastic parts to the point where they could fail. Such failure could cause serious
injury or property damage. See Technical Data on page 15 of this instruction manual and in all other
equipment manuals. Read fluid and solvent manufacturer's warnings.
CAUTION
ti3159a
309863A
• Before adding material to hopper, install burp guard. When only a small
amount of material remains in the hopper, the burp guard prevents material
from shooting out when the unit is turned off. This material could splash in
the operator's eyes or on skin, or into the air.
ti3158a
Water or material remaining in unit when temperatures are below freezing can damage
motor and/or delay pump startup. Do not allow unit to freeze.
To insure water and material are completely drained out of unit:
1. Remove material line from sprayer.
2. Tip sprayer up as shown.
Before adding material or starting unit in cold weather, run warm water through pump.
WARNINGS
3

Advertisement

Table of Contents
loading

Table of Contents