Voltage Selector Switch - Honda EM5000SX Owner's Manual

Voltage Selector Switch

The power available to each receptacle depends on the position of the voltage
selector switch.
Switch
Receptacle
Position
120V ONLY
120V/240V
120V ONLY POSITION
When the voltage selector switch is in the 120V ONLY position, you do not need
to spread the load over the receptacles. You must, however, make sure the load
on any receptacle does not exceed its available power shown in the table above
and the total load does not exceed the total current available.
Total Current Available:
37.5 A (EM5000SX) / 45.8 A (EM6500SX)
120V/240V POSITION
When the voltage selector switch is in the 120V/240V position, you must
balance the load. Divide the load between the two sets of receptacles shown
below. Balancing is necessary because each set of receptacles is powered by
only one power producing circuit that can produce a maximum of amps(*).
*:
18.8 A (EM5000SX) / 22.9 A (EM6500SX)
Set of
Receptacles
+ +
+
EM5000SX
30A at 120V
20A at 120V
20A at 120V
30A at 120V
18.8A at 120V
18.8A at 120V
18.8A at 120V
18.8A at 240V
-
Total Current Available
EM5000SX
18.8A
18.8A
Available Power
None
EM6500SX
22.9A
22.9A
OPERATION
EM6500SX
30A at 120V
20A at 120V
20A at 120V
30A at 120V
None
22.9A at 120V
20A at 120V
20A at 120V
22.9A at 240V
Power Producing
Circuit
B
A
57