Table of Contents
Advertisement
Table 8:
Supported SFP/SFP+ Modules
SFP/SFP+
SFP-10G-ER
SFP-10G-ZR
Table 9:
Supported DAC Cables
DAC
DAC-SFP-10GE-50CM
DAC-SFP-10GE-1M
DAC-SFP-10GE-3M
DAC-SFP-10GE-5M
DAC-SFP-10GE-7M
USB Interface
The W-7205 controller is equipped with two USB 2.0 interfaces; one on the front panel of the controller and the
other on the CPU module in the back panel of the controller. A USB storage device can be used to save
configurations, upload configurations, and upgrade image to the controller. USB functions are controlled through the
LCD panel on the front of the controller. For more information on the LCD panel and its functions, see
Panel" on page
17.
Serial Console Port
For direct local management of the controller, use the serial console port located on the front (see
port is an RJ-45 female connector that accepts an RS-232 serial cable with a male connector.
Figure 5
Serial Console Port Pin-Out
Serial
Console Port
The communication settings for the console port are shown in the following table:
Table 10:
Console Terminal Settings
Baud Rate
9600
Dell Networking W-7205 Controller | Installation Guide
Description
SFP+, 10GBASE-ER, 1310nm pluggable 10GE optic; up to 40,000 meters over single-mode fiber, LC connector
SFP+, 10GBASE-ZR, 1310nm pluggable 10GE optic; up to 70,000 meters over single-mode fiber, LC connector
Description
50cm Direct Attach Cable; 10G SFP+
1m Direct Attach Cable; 10G SFP+
3m Direct Attach Cable; 10G SFP+
5m Direct Attach Cable; 10G SFP+
7m Direct Attach Cable; 10G SFP+
RJ-45 Female
Pin-Out
1
2
3
TxD
GND
4
5
GND
6
RxD
7
8
Direction
Input
Output
Data Bits
8
Parity
Stop Bits
None
1
"LCD
Figure
5). This
Flow Control
None
W-7205 Controller | 15
Advertisement
Table of Contents
