Table of Contents
Advertisement
USB Interface
The W-7024 controller is equipped with a USB 2.0 interface on the back panel of the controller. A USB storage
device can be used to save and upload configurations to the controller. USB functions are controlled through the
LCD panel on the front of the controller. For more information on the LCD panel and its functions, see
Panel" on page
14.
Serial Console Port
For direct local management of the controller, use the serial console port located on the back panel of the controller.
The port is an RJ-45 female connector that accepts an RS-232 serial cable with a male connector.
Figure 5:
Serial Console Port Pin-Out
Serial
Console Port
The communication settings for the console port are shown in the following table:
Table 12:
Console Terminal Settings
Baud Rate
9600
CAUTION: The Console port is compatible only with RS-232 devices. Non-RS-232 devices, such as APs, are not supported.
ATTENTION: Le port CONSOLE est compatible uniquement avec les périphériques RS-232. Les périphériques qui ne sont pas de type
RS-232, notamment les points d'accès, ne sont pas pris en charge.
CAUTION: Do not connect the Console port to an Ethernet switch or a PoE power source. This may damage the controller.
ATTENTION: Ne connectez pas le port Console sur un commutateur Ethernet ou une source d'alimentation PoE. Sinon, vous risquez
d'endommager le contrôleur.
Serial Console Port Adaptor
A modular adaptor can be used to convert the female RJ-45 connector to a male DB9 connector. See
details.
Dell Networking W-7024 Controller | Installation Guide
RJ-45 Female
Pin-Out
1
2
3
TxD
4
GND
5
GND
6
RxD
7
8
Direction
Input
Output
Data Bits
Parity
8
None
Stop Bits
Flow Control
1
None
"LCD
Figure 6
for
W-7024 Controller | 16
Advertisement
Table of Contents
