Table of Contents
Advertisement
Table 13:
LCD Panel Mode
LCD Mode
Status
Maintenance
Disabling the LCD Screen
By default, the LCD screen is enabled. However, if the W-7205 controller is deployed in a location without physical
security, the LCD screen can be disabled through the CLI. When disabled, pushing one of the navigation buttons
will only illuminate the LCD screen and display the slot, role, device name, and any alarms.
Additionally, it is possible to disable only the maintenance menu. This allows to change the LED behavior and view
the device status but prevent upgrades and configuration changes.
To disable the LCD screen, enter the Enable mode and use the following CLI commands:
(host) #configure terminal
(host) (config) #lcd-menu
(host) (lcd-menu) #disable menu
To disable only the Maintenance menu or one of its sub-menus, enter the Enable mode and use the following CLI
commands:
(host) #configure terminal
(host) (config) #lcd
(host) (lcd-menu) #disable menu maintenance ?
factory-default
halt-system
media-eject
reload-system
upgrade-image
upload-config
(host) (lcd-menu) #disable menu maintenance upgrade-image ?
partition0
partition1
18 | W-7205 Controller
Function
Displays the ArubaOS version.
Allows execution of some basic
operations such as uploading an
image or rebooting the controller
Displayed Status/ Command
Exit
OS Version
Exit
Upgrade Image [Partition 0 [Y|N] |
Partition 1 [Y|N]]
Upload config [Y|N]
Factory Default [Y|N]
Media Eject [Y|N]
Reload system [Y|N]
Halt system [Y|N]
Exit
Dell Networking W-7205 Controller | Installation Guide
Description
Exit LED menu
ArubaOS version
Exit Status menu
Upgrade the controller image on
the selected partition from a
predefined location on an
attached USB flash device
Upload the controller's current
configuration to a predefined
location on the attached USB
flash device
Reset the controller to factory
default settings
Complete reading or writing to
the attached USB device
Reload controller
Halt controller
Exit Maintenance menu
Advertisement
Table of Contents
