LG Pro:Centric 32LT560H Setup Manual page 43

(Continued from previous page)
Note: If the ".tlx" file does not include an FTG Channel Map, the message, "No Channel Map
in Clone file," will be displayed at the right of the screen.
10. When you are ready to continue, press OK on the Installer Remote.
Import progress will be displayed on the screen. This process may take a few minutes.
Do NOT remove the USB device while importing is in progress. When the import process is
complete, an "Import Clone File complete" message will briefly be displayed, and then the TV
will exit the TV Manager.
11. Remove the USB memory device from the Target TV, and verify that the appropriate
configuration is now resident on the Target TV.
Note: If the Target TV was previously in Pass-through Mode and the Clone/Configuration (.tlx)
file that was imported contained an FTG Channel Map, the Target TV CPU is now in FTG Mode.
After the import process is complete, the TV tunes according to the Start Channel setting in the
Installer Menu. If a Start Channel is specified, the TV will tune to that channel, though, in the
case of FTG Mode configuration, a channel banner will only be displayed if the Start Channel is
included in the FTG Channel Map (depending on your selection in step 9, the channel banner
will display either the Start Channel's logical channel number or physical RF channel number).
Otherwise, the TV will either return to the last channel tuned (TV in Pass-through Mode) or tune
to the first channel in the FTG Channel Map (TV in FTG Mode). If the latter, remember that the
channels in the FTG Channel Map are always arranged in logical order, regardless of your selection
in step 9.
206-4339
Cloning Procedures (Cont.)
43