LG Pro:Centric 32LT560H Setup Manual page 34

Installer Menu (Cont.)
Note: Pro:Centric updates are downloaded from the Pro:Centric
server to the TV when the TV is turned OFF. While Pro:Centric
updates are in progress, it is not possible to turn ON the TV.
Note: The Data Channel is automatically set to "253" if Media
Type is set to "IP" either in the EZ-Manager Wizard or in the IP
Environment / Pro:Centric Menu on the TV (see "EZ-Manager
Wizard" on pages 12 to 20 or "Pro:Centric Setup" on pages 52 to
54, respectively) or if Installer Menu item #119 Data Channel is
set to "IP Address" in the Cloud Configuration Tool, which is
typically used to configure TV CPUs for FTG Mode operation. It
is not possible to change the value to "253" directly in the Installer
Menu.
121 - UPDATE TIME HR
Based on the settings of this item and item 122 UPDATE TIME MN,
the Wake For Update feature wakes the TV once daily to check for
and, if applicable, download updates from the Pro:Centric server.
Set the Wake For Update hour from 0 to 23. This item uses the
24-hour clock format. The value "128" (default) is displayed as
"OFF." Directly entering 128 resets the default value (OFF) for this
item, though note that this setting does not mean the TV will not
initiate update events—see additional information below.
Under standard TV OFF/ON operating conditions (i.e., item 002
AC ON is set to 0), a Wake For Update event occurs when the TV
is OFF and causes the TV's CPU to temporarily turn ON, perform
the update cycle, and then turn back OFF, all while the TV appears
to be OFF. If item 002 AC ON is set to 2, 3, 18, or 19 for Instant
ON, then the TV's CPU is always ON and Wake For Update occurs
when the TV is in its Muted ON state (i.e., the TV only appears to
be OFF). The Wake For Update event causes the TV's CPU to
reboot in order to perform the update cycle and then return to its
Muted ON state. See also description for item 002.
If this item is set to 128 (OFF), the time at which a Data Channel
Auto Search (item 119 set to 255) and/or an Instant ON update
(item 002 set to 2, 3, 18, or 19) occurs is determined as follows:
The TV initiates the search and/or checks for updates at 2:00
AM (if the TV clock is set) or after two hours of elapsed time from
when AC power was applied (if the TV clock is not set). If the
TV display is ON when a Wake For Update event is to occur, the
update will take place the next time the TV is turned OFF.
Caution: UPDATE TIME HR should NEVER be set to 255.
This setting is intended for factory use only.
Note: This item is not available in the Installer Menu when item
119 DATA CHANNEL is set to 0, except when item 002 AC ON is
set to 2, 3, 18, or 19 for Instant ON.
Note: The TV clock must be set in order for a Wake For Update
event to occur at the precise time of day in accordance with item
121 and item 122 settings.
34
122 - UPDATE TIME MN
Set the Wake For Update minute from 0 to 59. See also description
for item 121 UPDATE TIME HR above.
Note: This item is not available in the Installer Menu unless item
121 UPDATE TIME HR is set from 0 to 23.
Note: The TV clock must be set in order for a Wake For Update
event to occur at the precise time of day in accordance with item
121 and item 122 settings.
206-4339