Table of Contents
Advertisement
Step 3 of 6
Handlebar set up
Turn
1.
Turn handlebars clockwise and align with front wheel
2.
Tighten the two stem clamp bolts Max. 7Nm
Caution: The fork steerer tube is carbon fibre construction, which
can be seriously damaged by over tightening.
Failure to correctly tighten stem clamp bolt may result in serious
injury or death. If in doubt, please consult our technical support
team on +44 (0)800 008 6297 or email techsupport@islabikes.co.uk.
Before riding check front brake operation is correct. To check this,
apply both the front and rear brake, they should feel the same.
Secondly, push the bike forward whilst holding the front brake to
ensure it is working.
Icons - Janis
Do Not Over
Tighten
Tighten
Step 4 of 6
Pedal installation
(not supplied with bike)
a. Left pedal
Tighten
Tighten
Left pedal: Rotate pedal axle clockwise towards front of bike
1.
2.
Right pedal: Rotate pedal axle anti-clockwise towards front of bike
Tighten max. 30Nm
Please ensure you identify the left and right pedals before installing.
b. Right pedal
www.islabikes.co.uk
Advertisement
Table of Contents
Need help?
Do you have a question about the Icons Janis and is the answer not in the manual?