Configuring Dhcp - AT&T U115 Install Manual

Configuring DHCP

To configure DHCP, follow these steps after reaching
1. Select the radio button next to "DHCP" on
2. Select the DHCP options required by your ISP on
set.
3. Press OK to save the new settings.
4. At the end of the setup, you will be asked to reboot to pick up the new configuration. After reboot, skip to the
section titled "Establishing VPN Connectivity" on page 20.
Figure 4
:
Figure 4
and click OK to proceed to the DHCP set up window.
Figure 5
. Most ISPs do NOT require any of these values to be
Figure 5: DHCP Settings
11