Operation - ElectrIQ ECOSILENT8 User Manual

OPERATION

Cool
Dry
Fan
Swing Mode
Power
Press the POWER button to turn the unit ON or OFF.
Cool Smart Cool
Press the MODE button to cycle between the 4 modes, the indicator for the selected mode will
Dry
be illuminated.
COOL: The room is cooled with the cold air expelled through the front air outlet while hot air is
Fan Timer
expelled through the vent pipe. The desired room temperature can be set between 17 and 30
degrees using the + and – buttons, and the fan speed can be changed using the SPEED button.
FAN: The fan speed can be changed pressing the SPEED button.
Mode Timer
DRY: Should be operated without the vent hose, but with continuous drainage to remove
High
moisture from the air. The display will show dH and the unit will run in low fan speed.
Mid
SMART COOL: An intelligent cooling mode where the fan speed is automatically adjusted based
Power
on the amount of cooling required. Attempts to change the fan speed will move the unit into
Low
COOL mode.
Repeatedly press the SPEED button to cycle through the five fan speeds. Each time the SPEED
High
Speed
button is pressed, the fan speed will be displayed. The fan speed can be changed between F1
Mid
(Low) to F5 (High). The LED indicators will also illuminate to show the fan speed as below:
Sleep Low
The fan speed cannot be changed in SMARTCOOL and DRY modes.
Press to enter sleep mode. The sleep indicator will be illumined and all other indicators will be
Sleep Speed
turned off. In sleep mode, the appliance works at low fan speed. Press SLEEP again to exit sleep
mode.
The timer functions cannot be combined or repeated.
POWER ON TIMER
Timer
With the appliance in standby, press the TIMER button to set the power-on timer. Use the + and
- buttons to adjust the duration of the timer (1 to 24 hours). The Timer indicator will turn on and
the unit will start after the selected number of hours.
Timer
POWER OFF TIMER
With the appliance running with the desired settings, press the TIMER button to set the power-
off timer. Use the + and - buttons to adjust the duration of the timer (1 to 24 hours). The timer
indicator will illuminate and the unit will stop after selected number of hours.
Cool
Sleep
Used to adjust the temperature in COOL/SMART COOL mode and to set the duration of the TIMER.
Dry
The buttons are not used in FAN or DRY modes. Press both buttons together to change between
Fan
displaying the temperature in Celsius and Fahrenheit.
Sleep
Press this button to enable the swing function. The louvres will slowly move from side to side. If
Swing Mode
swing is pressed again the louvres will stop in their current position.
Press and hold the swing button to turn off the status indicators on the control panel.
Smart Cool
Timer
Timer
Power
F1 –Low, F2 – Low and Mid, F3 – Mid, F4 – Mid and High, F5 – High.
Sleep
Sleep
High
Mid
High
Sleep Low
Mid
Smart Cool
Power
Low
Sleep Speed
Timer
Speed
Timer
Sleep
Sleep
Sleep
Sleep
High
Mid
Low
Speed
Power
8
High
Mid
Power
Low
Speed
High
Mid
Power
Low
Speed
Power
High
Mid
Sleep Low
Sleep Speed
Pow