Chapter4. Receipt Printer (Spr60); Introduction - HYOSUNG MONiMAX8100T Operator's Manual

Operator Manual

Chapter4. Receipt Printer (SPR60)

Introduction

► Information in this section is subject to change without notice. Hyosung TNS reserves the right to
improve products as new technology, components, software, and hardware become available. If
users need further data about these products, please feel free to contact Hyosung TNS or your
local dealer.
No part of this document may be reproduced or transmitted in any form or by any means for any
purpose without the express written permission of Hyosung TNS.
► Warning and caution:
► Safety instructions
Before installing and using the printer, please read the following items carefully:
1. Install the printer on a flat and stable surface;
2. Reserve adequate space around the printer so that convenient operation and maintenance
3. Keep the printer far away from water source, and do not expose the printer to direct sunlight,
4. Do not use or store the printer in a place exposed to high temperature, high humidity or
5. Do not place the printer in a place exposed to vibration or impact;
6. No condensation is allowed to the printer. In case of such condensation, do not turn on the
7. Connect the printer power to an appropriate grounding outlet. Avoid sharing one electrical
8. Disconnect the power when the printer is deemed to idle for a long time;
9. Don't spill water or other electric materials into the printer (e.g. metal). In case this happens,
10. Do not allow the printer to start printing when there is no recording paper installed; otherwise
11. To ensure quality print and normal lifetime, use recommended paper or its equivalent;
12. Shut down the printer when connecting or disconnecting interfaces to avoid damages to
13. Set the print darkness to a lower grade as long as the print quality is acceptable. This will
14. Do not disassemble the printer without permission of a technician, even for repairing
15. Keep this manual safe and at hand for reference purpose.
Caution: Items shall be strictly followed to avoid injury or damage to body and equipment.
Note: Items with important information and prompts for operating the printer.
Heating: Thermal elements. No touching.
Warning: Do not touch equipment to avoid damaging it for static electricity.
can be performed;
strong light and heat;
serious pollution;
power until it has completely gone away;
outlet with large power motors or other devices that may cause the fluctuation of voltage;
turn off the power immediately;
the print head and platen roller will be damaged;
control board;
help to keep the print head durable;
purpose;
© Hyosung TNS Inc. All Rights Reserved.
Chapter4. Receipt Printer (SPR60)
4-1