Table of Contents
Advertisement
wasco
®
By default, the EXDUL-581 is set to DHCP client. To access the EXDUL-581
the used PC has to be set to ‚IP-Adresse automatisch beziehen (DHCP-
aktiviert)' and the network has to provide a DHCP server (integrated in most
of the routers). The DHCP server automatically assigns a subnet mask and
an IP address to the EXDUL-581 and to the computer. If the basic setting
has been changed to static IP address, the used computer also has to be
set to static address (Folgende IP-Adresse verwenden).
Example: The static IP address for the EXDUL-581 is 192.168.1.199
(network ID: 192.168.1., device ID 199). To access the EXDUL-581 the
used PC has to be set to subnet mask 255.255.255.0 and to static IP
address ranging from 192.168.1.1 up to 192.168.1.244
How to check the network configuration of the PC
You can monitor the TCP/IP settings of your computer via the Internet
Protocol Version 4 (TCP/IPv4) Properties window or the status of the LAN
connection respectively (see „How to check and to change IP address of
the PC"). Alternatively type the simple command IPCONFIG to the com-
mand-line. For this, switch to the MS-DOS prompt (see „How to switch to
MS-DOS prompt"), type ipconfig and press enter to confirm. The response
should look similar to the following figure:
EXDUL-581E / EXDUL-581S © 2019 by Messcomp Datentechnik GmbH
EV03
89
Advertisement
Table of Contents
