Fayat Group BOMAG BT 65 Operating Instruction, Maintenance Instruction page 73

Fig. 59
Fig. 60
Fig. 61
Fig. 62
5. Align the alignment mark on the flywheel rib with the top bore
in the fan cover.
ð The piston is in top dead centre position of the compres-
sion stroke.
6. However, if the exhaust valve is open when aligning the
marks, the flywheel must be turned further by 360°.
7. Measure the valve clearance with a feeler gauge (2).
8. To adjust the valve hold the valve adjustment screw (1) and
loosen locking nut (3).
9. Turn the valve adjustment screw in or out, as required.
10. Retighten the locking nut, tightening torque: 8 Nm (6 ft·lbf).
11. Clean the sealing faces on cylinder head cover and cylinder
block.
12. Apply a bead of approx. 1.5 to 2.0 mm (0.06 to 0.08 in) in
diameter of the fluid sealant to the inner side of the cylinder
head cover.
Liquid sealant: Three Bond 1207B or similar.
13. Attach the cylinder head cover to the cylinder block within the
next 10 minutes.
14. Tighten the fastening screws.
BT 65
Maintenance – Annually
77