Dell Alienware Area-51 R5 Service Manual page 114

Advanced
BIOS Auto-Recovery
Always Perform Integrity Check
CPU configuration
Hyper-threading Technology
Intel (R) SpeedStep (tm)
Virtualization
VT for Direct I/O
Active Processor Cores
Integrated Devices
Front USB Port
Rear USB Port
ASMedia XHC Controller
HD Audio
Integrated NIC1
Integrated NIC2
Pxe Option
SATA Mode
PCIE GEN3
Power Management Setup
AC Recovery
Deep Sleep Control
Auto Power On
Numlock Key
114
Enable the user to recover from certain corrupted BIOS conditions
from a recovery file on the user primary hard drive. Default:
Disabled.
Allows you to perform the Integrity check. Default: Disabled.
Enable or disable HyperThreading in the processor. Default:
Enabled.
Enable or disable Intel Speedstep Technology. Default: Enabled.
NOTE: If enabled, the processor clock speed and core
voltage are adjusted dynamically based on the processor
load.
Allows you to enable or disable the Intel Virtualization technology.
Default: Enabled
Specify whether a Virtual Machine Monitor (VMM) can utilize the
additional hardware capabilities provided by Intel Virtualization
Technology for Direct I/O. Default: Enabled.
Allows you to enable or disable the front USB ports. Default:
Enabled.
Allows you to enable or disable the rear USB ports. Default:
Enabled.
Allows you to enable or disable the XHC controller. Default:
Enabled.
Allows you to enable or disable the integrated audio controller.
Default: Enabled.
Allows you to enable or disable the NIC1. Default: Enabled.
Allows you to enable or disable the NIC2. Default: Enabled.
Allows you to enable or disable the boot option for legacy network
devices. Default: Disabled.
Allows you to configure the operating mode of the integrated
SATA hard drive controller.
Default: Inte Smart Response Technology.
Allows you to enable or disable the PCIE GEN3. Default:
Disabled.
Sets what action the computer takes when power is restored.
Default: Last State.
Allows you to define the controls when Deep Sleep is enabled.
Default: Enabled in S5 Only.
Enable to set the computer to turn on automatically every day or
on a preselected date and time. This option can be configured only
if the Auto On Time is set to Everyday, Weekdays, or Selected
Days.
Default: Disabled.
Enable or disable Numlock.
Default: Enable Numlock.