Table of Contents
Advertisement
AIR VANTAGE
600X
®
BATTERY HANDLING
WARNING
GASES FROM BATTERY can
explode.
battery.
To prevent EXPLOSION when:
• INSTALLING A NEW BATTERY - disconnect
connect to new battery last.
• CONNECTING A BATTERY CHARGER -
Remove battery from welder by disconnecting
battery clamp. When reinstalling, connect negative cable
last. Keep well ventilated.
then connect negative lead to engine foot.
BATTERY ACID CAN BURN EYES AND SKIN.
• Wear gloves and eye protection and be careful
when working near battery. Follow instructions
printed on battery.
PREVENTING ELECTRICAL DAMAGE
1. When replacing, jumping, or otherwise connecting the battery
to the battery cables, the proper polarity must be observed.
Failure to observe the proper polarity could result in damage
to the charging circuit. The positive (+) battery cable has a
red terminal cover.
2. If the battery requires charging from an external charger,
positive battery cable before attaching the charger leads.
Failure to do so can result in damage to the internal charger
components. When reconnecting the cables, connect the
PREVENTING BATTERY DISCHARGE - Turn the
RUN/STOP switch to stop when engine is not running.
PREVENTING BATTERY BUCKLING - Tighten nuts on
battery clamp until snug.
CHARGING THE BATTERY -When you charge, jump,
replace, or otherwise connect battery cables to the battery, be
sure the polarity is correct. Improper polarity can damage the
charging circuit. The Air Vantage
terminal has a red terminal cover.
If you need to charge the battery with an external charger, discon-
attach the charger leads. After the battery is charged, reconnect
to do so can result in damage to the internal charger components.
Follow the instructions of the battery charger manufacturer for
proper charger settings and charging time.
600X positive (+) battery
®
ENGINE OIL CHANGE
Drain the engine oil while the engine is warm to assure rapid and
complete draining. It is recommended that each time the oil is
• Be sure the unit is off. Disconnect the negative battery cable
to ensure safety.
• Locate oil drain hose and valve in bottom of base and pull
through the hole in the battery access panel on the welder.
• Remove the cap from the drain valve. Push valve in and twist
counterclockwise. Pull to open and drain the oil into a suitable
container for disposal.
• Close the drain valve by pushing in and twisting clockwise.
Replace the cap.
•
cap securely.
• Push oil drain hose and valve back into unit, re-connect
negative battery cable, and close doors and engine top cover
before restarting unit.Wash your hands with soap and water
after handling used motor oil. Please dispose of used motor
oil in a manner that is compatible with the environment. We
suggest you take it in a sealed container to your local service
station or recycling center for reclamation. DO NOT throw it in
the trash, pour it on the ground, or down a drain.
SAE 10W-30 oil that meets API class CJ-4 or better is
recommended for general, all temperature use, 5F to 104F (-15C
to 40C).
viscosity recommendations.
Oil Filter Change
• Drain the oil.
•
in any way the fuel lines.
•
•
additional 1/2 to 7/8 of a turn.
•
tighten securely.
•
• Stop the engine and check the oil level. If necessary, add oil
to the upper limit mark on the dipstick.
D-5
MAINTENANCE
Advertisement
Table of Contents
