Advertisement
step 7.
pre-drilled holes
Begin by installing all of the screws along one
hole for anti-tip strap
edge of the back panel. Next, using a square
or tape measure, make sure that the cabinet is
square. (If using a tape measure, the distance
from one corner, diagonally to the other corner
Q
should be the same in both directions.) Install
the remaining screws, starting with the corners.
(H5) x 21
5/8'' pan-head screw
pre-drilled holes
1. Make sure the screws go through the pre-drilled holes.
2. Do not over tighten screws.
13
Advertisement
