Page 1
WE-EF LEUCHTEN Installation and Maintenance Instructions Inground Luminaire ETC130-FS LED EVC130-FS LED ETC140-FS LED EVC140-FS LED Do not open during installation Surge Protection This product is factory-sealed. This product features built-in surge protection circuitry in compliance with Refer to the instructions contained in this applicable standards.
Page 2
Inground Luminaire ETC130-FS EVC130-FS ETC140-FS EVC140-FS IP67, Class I, ta = 40°C...
Light Source Maintenance Apart from cleaning the product’s exterior surfaces, no special maintenance work is required. Do not use high-pressure cleaners. In case of component failure due to abnormal circumstances or at end of life, replacement must be carried out by a suitably quali ed and trained professional.
Installation Installation Methods The product must be installed and maintained by a For proper installation, use the supplied installation suitably quali ed professional in compliance with latest blockout. building/construction and/or electrical regulations and relevant legislation. Ensure that proper drainage is provided for the shown installation methods: Warning: Switch off mains electrical supply prior to In landscape areas, sand with gravel base (Fig.
Page 5
Phase One Phase Two Blockout Installation Procedure Luminaire Installation and Electrical Connection (during earth or masonry work) 4) Switch off mains electrical supply. 1) Ensure a suitable recess is provided to accommo- 5) Check that rating shown on luminaire label conforms date installation blockout/mounting ring assembly with mains electrical supply.