Table of Contents
Advertisement
3.
Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lb (29 cm-kg).
FIGURE 21 Attaching the rear brackets to the rack posts
1.
Screws, 10-32 x 5/8-in., panhead Phillips
Flush-rear (recessed) mounting
The flush-rear (recessed) mounting is similar to the flush-front mounting except that the brackets are reversed on the device.
CAUTION
The device must be turned off and disconnected from the fabric during this
procedure.
NOTE
The illustrations in the rack installation procedures show a 1U device, but the instructions are the same for a 2U device. The
illustrations in the rack installation procedures are for reference only and may not show the actual device.
Complete the following tasks to install the device in a four-post rack:
1.
Attaching the front brackets to the rear of the device
2.
Attaching the extensions to the front of the device
3.
Installing the device in the rack
4.
Attaching the rear brackets to the extensions at the front of the device
5.
Attaching the rear brackets to the front rack posts
ExtremeSwitching SLX 9030 Hardware Installation Guide
9035691-02 Rev AD
on page 50
on page 50
on page 51
on page 54
Installing the Universal Four-Post Rack Kit (XEN-R000296)
2.
Retainer nuts, 10-32
on page 52
49
Advertisement
Table of Contents
