Output - RadioMaster TX12 Instruction Manual

Modes: Select the corresponding flight mode, and the output trimming value
that affects this entry can be set by the flight mode entry
Switch: Select the switch to activate this item (Note: This setting is added to this
item to add multiple lines of different settings to switch, if there is only one line
setting, do not set the activation switch, otherwise the switch will cause this
item to be completely invalid).
Warning: Set the alert tone
Multpx: Superposition method, output after superimposing with the value of
the previous stroke amount
Add: Additive superposition, the current value is added to the value of the
previous line and output
Multiply: multiplication, the current value is multiplied by the value of the
previous line and output
Replace: direct replacement, the value of the previous line is directly
replaced by the value of this line
The combination of these operations allows the creation of complex
mathematical operations and is often considered one of the biggest benefits of using
OpenTX.
Delay Up/Dn: The response of the output can be delayed as the input changes.
(In seconds).
Up/Dn: Regarding input changes, the response of the output can be slowed.
Slow
For example, slow speed can be used to slow down retraction driven by a
normal proportional servo. The output will cover the time in seconds from 100
to + 100%.
4.4.6. Output（Outputs）
Total output page, final channel output overall settings
38