Default Gimbal Mode And Channel Output Order - RadioMaster TX12 Instruction Manual

Hide thumbs Also See for TX12:
Table of Contents

Advertisement

3.3. Set the default Gimbal mode and the default channel
output order.
In the system settings, turn the page to the RADIO SETUP page, select the scroll
wheel to the bottom of the page, you can see
Rx channel ord (Receiver channel order)
Mode(Gimbal mode)
Because the channel input order of the built-in multi-protocol transmitting
module of the RadioMaster TX12 radio control is AETR, in the Default channel order
option, be sure to select the AETR order
The Mode (gimbal mode) can be selected according to your personal
preferences:
Mode 1 (right-hand throttle / Common in Asian and some European markets)
or
Mode 2 (left-hand throttle / Common in North American markets)
The icons on the right from left to right indicate the names of the gimbals
corresponding to the position of the gimbal on the radio control.
Left gimbal horizontal / Left gimbal vertical / Right gimbal vertical /Right gimbal horizontal
Rud(Yaw)/ Thr(Thrust)/ Ele (Pitch) / Ail(Roll)
20

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents