Spinning; Final Spin Speed In Wash Programmes - Miele WWD 120 Operating Instructions Manual

Spinning

Final spin speed in wash
programmes
When a programme is selected, the
sensor for the optimum spin speed for
that programme will be brightly lit up in
the control panel.
A faster spin speed can be selected for
certain wash programmes.
The highest selectable spin speed is
indicated in the table.
Programme
Cottons 
Cottons
Minimum iron
Delicates
Woollens 
Shirts
Express 20
Dark garments/Denim
ECO 40-60
Proofing
Drain/Spin
Separate rinse/Starch
Rinse and interim spin
There is a spin after the main wash and
between the rinses. A reduction in the
final spin speed will also reduce the
interim spin speed. If a spin speed of
less than 700 rpm is selected for the
Cottons programme, an additional rinse
is introduced.
28
Deselecting Rinse hold (final
spin)
 Touch the  sensor (Rinse hold).
The laundry is not spun after the final
rinse and remains in the rinse water.
This helps prevent creasing if the
laundry is not going to be removed from
the drum immediately after the end of
the programme.
Ending a programme with a spin
cycle
rpm
The sensor for the optimum spin speed
1400
lights up in the control panel. You can
1400
change the spin speed.
1200
 Touch the Start/Add laundry sensor.
900
Ending a programme without a spin
1200
cycle
900
 Reduce the spin speed to .
1200
 Touch the Start/Add laundry sensor.
1200
1400
Omitting rinse and interim spin
1200
and the final spin
1400
 Touch the  sensor.
1200
After the last rinse, the water will be
pumped away and the Anti-crease
phase will switch on.
In some programmes an additional rinse
is introduced with this setting.