Raleigh Audio Premium Extreme RAKK dac Assembly Manual page 44

Wire the USB Adapter and connect it to the RAKK dac
Skip this section if you do not have a USB Adapter.
Skip this step if you do have a 3-Input I2S Adapter.
18. Locate the red/black twisted pair from the 8V Regulator and connect it to the 8V pads on the
USB Adapter. Connect the red wire to the "+" pad and the black wire to the "-" pad.
19. Dress the flat cable close to the chassis and connect it to the "Input 4 I2S" connector on the
RAKK dac
————————————————————————————
Wire the Single-Input I2S Adapter and connect it to the RAKK dac
Skip this step if you do not have a Single-Input I2S Adapter.
20. Locate the red/black twisted pair from the 5V Regulator and connect it to the 5V pads on the
I2S Adapter. Connect the red wire to the "+" pad and the black wire to the "-" pad.
21. Dress the flat cable close to the chassis and connect it to the "Input 4 I2S" connector on the
RAKK dac
————————————————————————————
Secure the RAKK dac
22. Secure the RAKK dac with four 6-32 screws.
————————————————————————————
43