Pre-Wire The 12V Power Supply (For The Active Output) - Raleigh Audio Premium Extreme RAKK dac Assembly Manual

Pre­wire the 12V Power Supply (for the Active Output)
————————————————————————————
12. Install a 10K resistor in location R4.
————————————————————————————
13. Prepare an 11" #22 red/black twisted pair.
• Connect the red wire to the DC Output "+" pad.
• Connect the black wire to the DC Output "-" pad.
————————————————————————————
14. Prepare a 9" long #20 green wire and connect it to the DC Output "+" pad.
————————————————————————————
15. Prepare a 13" #22 white/violet twisted pair.
• Connect the white wire to the LED "C" pad.
• Connect the violet wire to the LED "A" pad.
————————————————————————————
16. Prepare a 6" #20 white/black twisted pair.
• Connect the twisted pair to the inner-most "AC Input" pads.
————————————————————————————
17. Fabricate a T-shaped AC power cable as follows:
• Cut a #20 black wire, 7½ inches long. Do not strip the ends.
• Cut a #20 black wire, 23 inches long. Do not strip the ends.
• Cut a #20 white wire, 24½ inches long. Do not strip the ends.
• Align the white wire with the longer black wire and twist them together for about 18".
• Align the other black wire with the other end of the white wire and twist them together
for 4½".
• Go back to the first pair (that you twisted to 18") and continue the twist until you get to
the junction of the second pair.
• Now twist the two black wires together until you get to the end. Don't worry if the two
black wires are different length – you will trim them later.
————————————————————————————
12