Heatstore HSQH2000 Installation And Operating Instructions

Heatstore HSQH2000 Installation And Operating Instructions

Wall mounted infrared heater

Advertisement

SPECIFICATION: HSQH2000
: 2000W, 220-240V, ~50/60Hz; IP65;
RATING
: 630 x 160 x 115 mm; 2.55kG
DIMENSIONS
T WO YEAR
IP
2
65
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your local authority or retailer for recycling advice.
Telephone: 0117 923 5375 Fax: 0117 923 5374
Victoria Road, Avonmouth, Bristol BS11 9DB
www.heatstore.co.uk
Wall Mounted Infrared Heater
Installation and Operating Instructions
WHEN USING ANY ELECTRICAL APPLIANCE, BASIC SAFETY
PRECAUTIONS SHOULD ALWAYS BE FOLLOWED.
IF IN ANY DOUBT ABOUT THE INSTALLATION OR USE OF THIS
PRODUCT, CONSULT A COMPETENT ELECTRICIAN.
Issue 1 03/17
HSQH2000

IMPORTANT SAFEGUARDS

PLEASE READ ALL INSTRUCTIONS CAREFULLY
AND RETAIN FOR FUTURE REFERENCE

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HSQH2000 and is the answer not in the manual?

Questions and answers

Summary of Contents for Heatstore HSQH2000

  • Page 1 HSQH2000 Wall Mounted Infrared Heater Installation and Operating Instructions IMPORTANT SAFEGUARDS SPECIFICATION: HSQH2000 WHEN USING ANY ELECTRICAL APPLIANCE, BASIC SAFETY : 2000W, 220-240V, ~50/60Hz; IP65; RATING PRECAUTIONS SHOULD ALWAYS BE FOLLOWED. : 630 x 160 x 115 mm; 2.55kG DIMENSIONS...
  • Page 2 Important Safety Instructions • DO NOT connect the heater to the mains source • WARNING: In order to avoid overheating, do not until it has been installed in its final location and cover the heater. adjusted to the position it will be used in. •...
  • Page 3 Installation • CAUTION: Some parts of this heater can become very hot and cause burns. Particular attention has to The HSQH2000 Heater is supplied be given where children and vulnerable people are with 1.8m pre-fitted cable and all the required fixings in the box –...
  • Page 4 Switching on for the first use After switching on the heater for the first time and following extended periods on non-use, the heater may smell for a short time. It is normal to see two dark points on the bulb element in the following few minutes of switching on.

Table of Contents