Heatstore HSQH3000 Installation And Operating Instructions

Wall mounted infrared heater

Enlarged version

SPECIFICATION: HSQH3000

: 3000W, 220-240V, ~50/60Hz; IP65;

RATING

: 1035 x 160 x 115 mm; 3.9kG

DIMENSIONS

T W O YEAR

Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.

Check with your local authority or retailer for recycling advice.

Telephone: 0117 923 5375 Fax: 0117 923 5374

Victoria Road, Avonmouth, Bristol BS11 9DB

www.heatstore.co.uk

Wall Mounted Infrared Heater

Installation and Operating Instructions

WHEN USING ANY ELECTRICAL APPLIANCE, BASIC SAFETY

PRECAUTIONS SHOULD ALWAYS BE FOLLOWED.

PLEASE READ ALL INSTRUCTIONS CAREFULLY

IF IN ANY DOUBT ABOUT THE INSTALLATION OR USE OF THIS

PRODUCT, CONSULT A COMPETENT ELECTRICIAN.

Issue 1 03/17

HSQH3000

IMPORTANT SAFEGUARDS

AND RETAIN FOR FUTURE REFERENCE

Table of Contents

Do you have a question about the HSQH3000 and is the answer not in the manual?

Page 1: Important Safeguards
HSQH3000 Wall Mounted Infrared Heater Installation and Operating Instructions IMPORTANT SAFEGUARDS SPECIFICATION: HSQH3000 WHEN USING ANY ELECTRICAL APPLIANCE, BASIC SAFETY : 3000W, 220-240V, ~50/60Hz; IP65; RATING PRECAUTIONS SHOULD ALWAYS BE FOLLOWED. : 1035 x 160 x 115 mm; 3.9kG DIMENSIONS...
Page 2 Important Safety Instructions • DO NOT connect the heater to the mains source • WARNING: In order to avoid overheating, do not until it has been installed in its ﬁnal location and cover the heater. adjusted to the position it will be used in. •...
Page 3: Before Installation
• CAUTION: Some parts of this heater can become very hot and cause burns. Particular attention has to The HSQH3000 Heater is supplied with 1.8m pre-fitted cable and all the required fixings in the box. be given where children and vulnerable people are Fixings supplied: 6 x ST4*35 screws;...
Page 4 Switching on for the ﬁrst use After switching on the heater for the ﬁrst time and following extended periods on non-use, the heater may smell for a short time. It is normal to see two dark points on the bulb element in the following few minutes of switching on.