Table of Contents
Advertisement
Operating Instructions
10. OVERLOAD PROTECTION
When overloaded, the motor comes to a stop. Relieve the load on the tool immediately
and release the on/off switch. Restart the tool as normal.
11. TEMPERATURE DEPENDENT OVERLOAD PROTECTION
When using as intended for the power tool cannot be subject to overload. When the
load is too high or the allowable battery temperature is too hot, the electronic control
switches off the power tool until the temperature is in the optimum temperature
range again.
12. PROTECTION AGAINST DEEP DISCHARGING
The LITHIUM-ION battery is protected against deep discharging by the "Discharging
Protection System". When the battery is empty, the tool is switched off by means of a
protective circuit: The drill will no longer rotate. Remove the battery and recharge.
Trouble Shooting
Problem
Unit will not work
Battery will not
charge
Switch cannot be
pressed
12
Possible cause
1. Battery not installed properly
2. Battery not charged
1. Battery not installed into
charge
2. Charger not plugged into a
working outlet.
3. Surrounding air temperature
is too hot or too cold
Forward/Reverse switch at
middle position
Customer Helpline
1. Check battery installation
2. Check battery charging
requirements
1. Insert battery into charger until
red light appears
2. Plug charger into a working
outlet. Check current by plugging
in a lamp.
3. Move charger to an appropriate
place which temperature is
suitable for the charger.
Make sure switch is on Forward or
Reverse rotation according to
project need.
0345 640 0800
Solution
Advertisement
Table of Contents
