Loading Print Ribbon - DataCard SP55 Plus Printer Manual
Datacard sp55 plus: printer guide
Hide thumbs
Also See for SP55 Plus:
- Quick install manual (20 pages) ,
- Supplementary manual (2 pages) ,
- Printer manual (134 pages)
Table of Contents
Advertisement
Loading print ribbon
1
Open the printer.
2 Remove the ribbon cartridge.
3 Remove both used ribbon spools from the cartridge
(if present).
Tips: Handling print ribbon
•
Keep unused ribbon in the original package.
•
Don't place ribbon on a dusty or dirty surface–dirt
could damage the printhead.
4 Run a cleaning card and replace the cleaning sleeve
at the same time that you load a new print ribbon.
See "Cleaning the printer" on page 17 for the steps to
follow.
Page 7
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the SP55 Plus and is the answer not in the manual?
Questions and answers
I replaced the ribbon correctly, but when I attempt to print a card, it prints a portion of the top of the front of the card. The printer serial number is: H102552 Firmware version: 33.36
The issue may be caused by the print ribbon spools not being pushed completely onto the cartridge spindles. Push each print ribbon spool onto its spindle until it clicks into place. If the issue continues, contact your service provider.
This answer is automatically generated