Table of Contents
Advertisement
GRAVITY COMPENSATION
1. With the display showing
2. The display will change to show
3. Press the TARE key to show the Gravity compensation mode status.
4. Press the UNIT key to toggle between:
Enabled (display will change to
Disabled (display will change to
5. Press the TARE key and then the UNIT key.
6. The display will change to show
7. Press the TARE key to save the settings, reset the scale, and return to normal
weighing mode.
8. Setup is complete.
The Gravity Compensation for your scale has been pre-configured at the factory and should not
require changing in most locations. In the event that the factory settings do not meet the
requirements of your location, contact the factory for the value for your location.
With
GrAu
enabled in Configuration, the scale will use the factory set value of 9.7973 for
the Gravity Compensation.
If the
is disabled, the scale will use the value obtained from the factory and entered
GrAu
by the operator for the Gravity Compensation.
Change the Gravity Compensation Value
1. Press the ON/OFF key to turn on the scale.
2. Press and hold the UNIT key for approximately 3 seconds to enter the Gravity
Compensation setting mode.
3. The display will change to show
with the first decimal position blinking (the 7 in this example).
4. To enter the desired gravity value, press the TARE key to change the value of this digit
from 0 to 9.
5. Press the UNIT key to switch to the next digit, and then press the TARE key to change the
value of the digit from 0 to 9.
6. Repeat step 5 until the desired gravity value has been entered.
7. Press the ON/OFF key (to confirm the entered gravity value), and return the scale to the
normal operating mode.
10
CONFIGURATION, CONT.
BUrr
, press the press UNIT key.
.
GRAU
)
On
).
OFF
End
.
GRAVITY COMPENSATION
, and then change to
CADJ
8528-M310-O1 Rev C PS-11
(or the current value)
(7973
Advertisement
Table of Contents
