Installation ......1 PS-11 Digital Portion Scale. The PS-11 is equipped Unpacking ......1 with a rechargeable battery pack that (after 8 hours Power Supply .
The scale is now ready for operation. Battery Pack The scale uses a 7.2VDC, 1200 mA built-in rechargeable battery pack. The PS-11 can operate for up to 24 hours of continuous use with a fully charged battery pack.
(between the Under and the Over Limit settings). UNDER This annunciator tri-angle is turned on (with NO display backlight) to signal that the weight is less than the Under Limit setting. 8528-M310-O1 Rev C PS-11...
3. Press and hold the TARE key and the ON/OFF key for 3 seconds to enter the Configuration mode. 4. Press the TARE key to confirm the setting for each menu. 5. In Gravity Compensation mode, press the TARE key to choose number from 0~9. 8528-M310-O1 Rev C PS-11...
Display Backlight The PS-11 is equipped with a back lit display. The display backlight will be turned on during weighing and will automatically turn off 5 seconds after the weight has been removed from the scale.
CHECK WEIGHING The PS-11 allows you to set up the target accept settings for check weighing. The keyboard is used to enter in your Over and Under check weight limits. Set the Under and Over Limit Weights 1. Press the ON/OFF key to the turn scale on.
Over Limit weight setting. NOTE: The display will also show (with a RED display backlight) and the scale will beep three times when the weight is greater than the Over Limit weight setting. Over 8528-M310-O1 Rev C PS-11...
3. Press the UNIT key to toggle between: Enabled (display will change to Disabled (display will change to 4. Press the TARE key and then the UNIT key 3 times. 5. The display will change to Unit 6. Proceed to AUTOMATIC SHUTOFF. 8528-M310-O1 Rev C PS-11...
Page 13
3. Press the TARE key to display the buzzer (beeper) status. 4. Press the UNIT key to toggle between: Enabled (display will change to Disabled (display will change to 5. Press the TARE key and then the UNIT key. 6. Proceed to GRAVITY COMPENSATION. 8528-M310-O1 Rev C PS-11...
0 to 9. 6. Repeat step 5 until the desired gravity value has been entered. 7. Press the ON/OFF key (to confirm the entered gravity value), and return the scale to the normal operating mode. 8528-M310-O1 Rev C PS-11...
(-10%) CARE AND MAINTENANCE The heart of the PS-11 Digital Portion Scale is a precision load cell located in the center of the scale base. It will provide accurate operation indefinitely if protected against overload of scale capacity, dropping items on scale, or other extreme shock.
Page 16
Cardinal Scale Manufacturing Co. 203 E. Daugherty, Webb City, MO 64870 USA Ph: 417-673-4631 or 1-800-641-2008 Fax: 417-673-2153 Technical Support: 1-866-254-8261 E-mail: tech@cardet.com 8528-M310-O1 Rev C 12/18 IN-0866 4006C 8528-M310-O1 Rev C PS-11...