Gravity Compensation - Detecto VET-330WH Owner's Manual

Gravity Compensation

1. With the display showing
change to show
2. Press the HOLD key.
To Enable the Gravity Compensation mode, press the UNIT key. The display will
change to
To Disable the Gravity Compensation mode, press the UNIT key. The display will
change to
3. Press the HOLD key again. The display will change to show
4. Press the UNIT key. The display will change to show
5. Press the HOLD key to save the settings and reset the scale.
6. The setup is complete.
The Gravity Compensation for your VET-330WH scale has been pre-configured at the
factory and should not require changing in most locations. If the factory settings do not
meet the requirements of your location, contact the factory for the value for your location.
With enable from the function setting of the Configuration mode, the scale will use
the factory-set value of 9.796 for the Gravity Compensation.
If the is disabled, the scale will use the value obtained from the factory and
entered by the operator for the Gravity Compensation.
To Change the Gravity Compensation Value:
1. Press the ON/OFF key to turn on the scale.
2. Press and hold the UNIT key for 3 seconds to enter the Gravity Compensation mode,
the display will show 9.796 (or the current value).
3. Enter the desired gravity value (press the UNIT key to choose a number from 0~9,
and press the HOLD key to move to the right digit.
4. Press the TARE key (to confirm the entered gravity) and return the scale to the
normal operating mode.
10 1961-M045-O1 Rev B VET-330WH Owner's Manual
CONFIGURATION, CONT.
, press the press UNIT key 4 times. The display will
.
.
.
GRAVITY COMPENSATION
.
.