Starting The Engine - Alfa Romeo STELVIO Owner's Handbook Manual

Hide thumbs Also See for STELVIO:
Table of Contents

Advertisement

STARTING THE ENGINE

STARTING THE ENGINE
Before starting the engine, adjust the
seat, the interior rear view mirrors, the
door mirrors and fasten the seat belt
correctly.
Never press the accelerator pedal for
starting the engine.
If necessary, messages indicating the
starting procedure can be shown on the
display.
PROCEDURE FOR PETROL VERSIONS
119) 120) 121)
31) 32) 33)
Proceed as follows:
engage the electric parking brake
and set the gear lever to P (Park) or N
(Neutral);
fully depress the brake pedal without
touching the accelerator;
briefly press the ignition button;
if the engine doesn't start within a
few seconds, you need to repeat the
procedure.
If the problem persists, contact an Alfa
Romeo Dealership.
PROCEDURE FOR DIESEL VERSIONS
34)
Proceed as follows:
engage the parking brake and set the
146
gear lever to P (Park) or N (Neutral);
fully depress the brake pedal without
touching the accelerator;
briefly press the ignition button;
if the engine doesn't start within a
few seconds, you need to repeat the
procedure.
If the problem persists, contact an Alfa
Romeo Dealership.
STARTING AFTER A LONG INACTIVITY
If the car has not been started or driven
for at least four weeks, it is advisable to
follow the instructions below.
To start the engine, proceed as follows:
briefly press the ignition button;
if the engine does not start, wait 5
seconds and let the starter cool down
and then repeat the starting procedure;
if the engine does not start after 8
attempts, let the starter cool down for
at least 10 seconds and then repeat the
starting procedure.
If the problem persists, contact an Alfa
Romeo Dealership.
WARNING After prolonged vehicle
inactivity, very difficult starting, that
can be noticed through rapid fatigue
of the starter, might also be due to a
partially flat battery. In this case, see the
"Emergency starting" paragraph in the "In
an emergency" chapter.
ENGINE STARTING FAILURE
Important notes
Do not try to start the engine pouring
fuel or other flammable fluid inside
the throttle body air intake: this might
damage the engine and injury people
nearby.
Do not try to start the engine by towing
or pushing the vehicle. This manoeuvre
could let unburnt fuel enter the catalytic
converter. When the engine is started,
this would ignite, causing catalytic
converter overheating and damage.
If the battery is flat, you can jump
start the vehicle by connecting the
battery with an auxiliary one or with
one on another vehicle using suitable
cables. This manoeuvre can anyway
be dangerous when not performed
correctly. See the indications in the
"Emergency starting" paragraph in the "In
an emergency" chapter.
Starting the engine with electronic key
battery (Keyless Start) run down or flat
If the ignition device does not respond
when the relevant button is pressed the
electronic key battery might be run down
or flat. Therefore, the system does not
detect the presence of the electronic key
on board the car and displays a dedicated
message.
In this case, follow the instructions
in paragraph "Starting with flat key

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents