Alfa Romeo STELVIO Owner's Handbook Manual page 181

panel display the indication of the road
sign in the unit of measurement set.
TSR SYSTEM USE
System activation / deactivation
The system can be
activated/deactivated using the "Driver
Assistance" menu and then selecting
"Comfort" on the Connect system.
The system activation is signalled by
the road signs shown on the instrument
panel display.
Important notes
Selecting "Blinking" it is possible to
activate a warning when the effective car
speed exceeds that indicated by the TSR
system and displayed on the instrument
panel. In this case, the speed road sign on
the instrument panel display will blink
until the effective speed drops below
the displayed limit. Selecting "Offset",
it is possible to set the threshold at
which "Blinking" is activated, up to a
maximum of 6 mph (10 km/h) above the
limit detected by the system.
Indications on the display
The system status can always be
viewed through a dedicated area on the
instrument panel display.
This area contains the following road
sign information, from left to right within
the two dedicated zones:
the new speed limit recognised by the
system (1) fig. 201;
the "road sign not detected" (---)
indication, where applicable;
the no overtaking sign.
If the camera does not detect valid
speed limits, the navigation system may
suggest unregulated speed limits on the
display.
The previously displayed sign is no longer
valid after a certain distance has been
travelled if the system does not detect
other road signs, and the limit given by
the navigation system maps is indicated.
201
If a trailer and its light connector are
connected to the car, the instrument
panel display will show the additional
trailer connected sign.
NOTE The TSR system will always be
active every time the engine is started.
WARNING
158) The system only detects preset traffic
signs if the minimum visibility conditions
and distance from the sign are met.
159) The system is an aid for driving and
does not relieve the driver of responsibility
for driving the car. Always respect the
highway code of the country you are driving
in.
160) When the system is active, the driver
is responsible for controlling the car and
monitoring the system, and must be ready
to intervene as appropriate if necessary.
IMPORTANT
45) Functionality may be limited or the
system may not work if the sensor is
obstructed.
46) The system may have limited operation
or not work at all in weather conditions,
such as heavy rain, hail, thick fog and low
temperatures. Strong light contrasts can
influence the recognition capability of the
07076V0777EM
sensor.
47) The area surrounding the sensor must
not be covered with stickers or any other
object.
48) Do not tamper or perform any
operations in the area of the windscreen
glass directly surrounding the sensor.
49) Clean the windscreen glass from
foreign matters such as bird droppings,
insects, snow or ice. Use specific detergents
and clean cloths to avoid scratching the
windscreen.
179