Alfa Romeo STELVIO Owner's Handbook Manual page 167

that the car keeps the preset distance,
seeking to adapt to the speed of the
vehicle ahead.
In the cases described below, the system
performance is not guaranteed, it is
therefore advisable to turn the device on
by pressing the / CANCfig. 182 button:
driving in fog, heavy rain, snow, heavy
traffic and in complex driving situations
(e.g. on motorways with roadworks in
progress);
driving near a bend (winding roads),
icy, snowy, slippery roads or with steep
slopes and descents;
entering a turn lane or on a slip road;
towing a trailer;
when circumstances do not allow safe
driving at a constant speed.
ACTIVATION / DEACTIVATION
The device may have four operating
states:
Enabled (speed not programmed);
Activated (speed programmed);
Paused;
Deactivated.
Enabling / Activation
138)
To turn on the device, press and release
the / CANCfig. 182 button.
182
With the device enabled and ready for
operation, the display on the instrument
panel shows the white icon with dashes
fig. 183 in place of the speed.
183
Setting a speed activates the system.
The displays shows the green icon with
the set speed.
The device cannot be enabled when
RACE mode is active.
Pausing / Deactivating
With the device enabled (speed not set),
press the / CANC button.
With the device activated (speed set),
press the / CANC button to Pause; the
white icon appears on the display with
the speed value shown in brackets. Press
the / CANC button again to deactivate
the device completely.
07146V0050EM
SETTING THE DESIRED SPEED
Speeds from 30 km/h (or 19 mph if
the unit set by the driver is "mph") to
180 km/h (or 110 mph if the unit set by the
driver is "mph") can be set.
when the car reaches the desired speed,
raise/lower the RES/SET lever fig. 184
and release it to activate the device.
When the accelerator is released, the
car will maintain the selected speed
automatically.
05036S0182EM
184
Holding the accelerator pressed the
device will not be able to control the
07146V0051EM
165