Hitachi DH 36DBL Handling Instructions Manual page 39

7. About Remaining Battery Indicator
When pressing the remaining battery indicator
switch, the remaining battery indicator lamp lights
and the battery remaining power can be checked.
(Fig. 12)
When releasing your fi nger from the remaining
battery indicator switch, the remaining battery
indicator lamp goes off . The Table 5 shows the
state of remaining battery indicator lamp and the
battery remaining power.
State of lamp
As the remaining battery indicator shows somewhat diff erently depending on ambient
temperature and battery characteristics, read it as a reference.
NOTE
○ Do not give a strong shock to the switch panel or break it. It may lead to a trouble.
○ To save the battery power consumption, the remaining battery indicator lamp lights while
pressing the remaining battery indicator switch.
8. How to use the LED light
While the switch is pulled, the LED light will
automatically light up the tip portion of the
tool. (Fig. 13)
The LED light will automatically turn off 10
seconds after the switch is released.
9. Replacement of the drill chuck holder or the
drill bit holder
CAUTION
○ Prevent accidents, make sure to turn
the switch off and pull out the battery.
○ To avoid an injury by accident, before replacing the chuck, remove the tipped tool.
Table 5
The battery remaining power is enough.
The battery remaining power is a half.
The battery remaining power is nearly empty.
Re-charge the battery soonest possible.
39
Remaining battery
indicator switch
Battery Remaining Power
English
Remaining battery
indicator lamp
Fig. 12
Switch trigger
Fig. 13