Smith & Noble Metro Chic Hardware Installation Instructions Manual
Bay wall mount single rod set
Hide thumbs
Also See for Metro Chic Hardware:
- Installation instructions manual (11 pages) ,
- Installation instructions manual (11 pages) ,
- Installation instructions manual (9 pages)
Related Manuals for Smith & Noble Metro Chic Hardware
Summary of Contents for Smith & Noble Metro Chic Hardware
- Page 1 STEP BY STEP INSTALLATION INSTRUCTIONS Metro Chic Hardware Bay Wall Mount Single Rod Set...
-
Page 2: Table Of Contents
Everything Table of Contents You Need Getting Started ........3 Step 1 - Corner Bay Wall Mount Single Rod Set . -
Page 3: Step 1 - Getting Started
STEP 1 - GETTING STARTED OVERVIEW Getting Started Metro Chic Wall Bay Mount Rod Set Before you begin, check the accompanying diagram to make sure you have all the parts you need. You’ll need to make sure the surface you intend to install your hardware is sturdy enough to accommodate the brackets. -
Page 4: Step 2 - Mounting The Brackets
STEP 2 - MOUNTING BRACKETS STEP 2 - MOUNTING BRACKETS Place center of bracket cover plate Mounting the Brackets Figure A level against wall at the marked spots. Place the panel on one of the rods. Using a pencil, lightly draw a circle To ensure it drapes at the correct around the base of the bracket onto length, hold it up to the spot you... -
Page 5: Step 3 - Attaching The Rod Connector
STEP 3 - ATTACHING THE ROD CONNECTOR STEP 4 - PLACING CARRIERS & END STOPS (CON'T) Depending on your order, you may Placing End Stop on the Rod Split Draw have received a rod connector. A rod SCREWS End stop & Carrier positions connector is the short piece of metal SPLIT DRAPERY (A) -
Page 6: Step 6 - Attaching The Finials
STEP 6 - ATTACHING FINIALS STEP 7 - ATTACHING ELBOW BRACKET Elbow Bracket END CAP FINIALS Slide in End Cap onto rod and tighten set screw. Slide in elbow onto the end of the left rod where there is no finial end cap and End Cap can be attached with the tighten set screw. -
Page 7: Step 8 - Attaching Bracket Posts To Bracket Bases
STEP 8 - ATTACHING BRACKET POSTS TO BRACKET BASES STEP 9 - ATTACHING DRAPERY TO ROD Insert drapery pin hooks into carriers Align the mounting posts in the back of the left rod with the brackets mounted and master carriers. to the wall. -
Page 8: Care & Cleaning
ACCESSORIES CARE & CLEANING Baton/Wand (optional) Minimal care and cleaning is needed to maintain the beauty of your Hardware. Baton/Wand will be pre-attached to the To Vacuum: Use brush or dust head attachment. CLIP master carrier(s). To Dust: Use soft, clean cloth. BATON/ MASTER WAND... -
Page 9: Warranty
Warranty Service The enjoyment of your hardware should be everlasting, which is why our products come with a limited lifetime warranty. The warranty applies to the original owner, requires a proof of purchase (hang on to your receipt!) and covers defects in material or craftsmanship.
Need help?
Do you have a question about the Metro Chic Hardware and is the answer not in the manual?
Questions and answers