Disabling The Remote Start System - Directed Electronics Automate 553 Owner's Manual

The vehicle engine may be allowed to run for its pre-programmed
time period, or it can be shut down while running during Timer
Mode operation by pressing
again. In either case, the vehicle will restart every three hours for
a total of six operation cycles. If the system receives a shut-down
input while the engine is running in Timer Mode, the engine will
stop, but will restart, on schedule, again in three hours!
To exit Timer Mode:
Timer Mode can be exited by turning the ignition on with the key
any time that the vehicle engine is not running. You can also exit
Timer Mode using the transmitter by following these steps:
1. Start the engine by pressing
2. Press and release
3. Within two seconds, press and release
4. The vehicle engine will shut down and the parking lights will
flash four times to confirm Timer Mode has been exited. If the
vehicle has already been remote started, you may skip Step 1.

Disabling the Remote Start System

The remote start unit can be temporarily disabled to prevent the
vehicle from being remote started accidentally, which is useful if the
vehicle is being serviced or stored in an enclosed area. To disable
remote start, move the supplied shutdown toggle switch to the OFF
position. The switch can be installed in a location of your choice.
Check with your installer for recommended locations.
LOCATION OF SHUTDOWN SWITCH_________________________
18
and on the transmitter
and
.
1999 Directed Electronics, Inc.
©
simultaneously.
and again.