Table of Contents
Advertisement
IMPORTANT SAFETY INSTRUCTIONS
When installing and using this electrical equipment, basic safety precautions should always be
observed including the following. Failure to adhere to the safety warnings below may result in
severe injury, death or property damage.
READ AND FOLLOW ALL INSTRUCTIONS
This is the safety-alert symbol. When you see this symbol on your equipment or in this manual, look
for one of the following signal words and be alert to the potential for personal injury.
WARNING warns about hazards that could cause serious personal injury, death or major
property damage and, if ignored, presents a potential hazard.
CAUTION warns about hazards that will or can cause minor or moderate personal injury
and/or property damage and, if ignored, presents a potential hazard. It also makes consumers
aware of actions that are unpredictable and unsafe.
WARNING - RISK OF INJURY
•
Closely supervise children and pets at all times to ensure
they do not play with the cleaner – it is not a toy.
•
Ensure that children do not attempt to access the cleaner
while it is operating.
•
This appliance is not intended for use by persons with
reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by
a person responsible for their safety.
DO NOT PERMIT CHILDREN TO USE THIS PRODUCT.
•
NEVER swim with the cleaner in the pool.
•
Always disconnect and completely remove the cleaner
before entering the pool.
WARNING - RISK OF ELECTRICAL SHOCK
•
All electrical wiring MUST be in conformance with applicable
local codes and regulations (See table at end of document).
Always follow local code requirements. Hazardous voltage
can shock, burn, and cause death or serious property damage.
•
The cleaner should only be used with the provided cleaner
control unit, which supplies only Safety Extra Level Low
Voltage (SELLV) to the cleaner.
•
The cleaner control unit shall be located at least 3.5 m (11.5 ft.)
from the closest edge of the pool.
To reduce the risk of electric shock, DO NOT USE AN
•
EXTENSION CORD to connect control unit to electrical
outlet. This could create a safety hazard and/or damage
to the cleaner. Provide a properly located electrical outlet
per local building codes.
SAVE THESE INSTRUCTIONS
WARNING - RISK OF ELECTRICAL SHOCK
•
Disconnect the cleaner control unit from the electrical
outlet before carrying out any user maintenance. Before
working on any equipment, disconnect control unit
from the equipment.
•
Do not bury cable. Do not operate the cleaner with a
damaged cable. If the control unit power cord is damaged,
it must be replaced by the manufacturer, service agent, or
similarly qualified persons in order to avoid a hazard.
•
In the United States and Canada, the cleaner control unit
must be connected only to a supply circuit protected by a
ground-fault circuit-interrupter (GFCI). Contact a qualified
electrician if you cannot verify that the circuit is protected
by a GFCI. This GFCI should be tested on a routine basis.
To test the GFCI, push the test button. The GFCI should
interrupt power. Push reset button. Power should be
restored. If the GFCI fails to operate in this manner, the
GFCI is defective. If the GFCI interrupts power to the
cleaner control unit without the test button being pushed,
a ground current is flowing, indicating the possibility of
an electrical shock. Do not use the cleaner control unit.
Disconnect the cleaner control unit and contact the
manufacturer for assistance.
•
In Europe, Australia and New Zealand, the cleaner control
unit must be supplied through a residual current device
(RCD) having a rated residual operating current not
exceeding 30 mA. Contact a qualified electrician if you
cannot verify that the circuit is protected by a RCD.
•
Never allow the plug to enter the water.
Advertisement
Table of Contents
