Hayward ABOVE GROUND Series Owner's Manual

Hayward ABOVE GROUND Series Owner's Manual

Suction pool cleaner
Hide thumbs Also See for ABOVE GROUND Series:

Advertisement

ISM926 Rev. A
ABOVE GROUND SERIES
Suction Pool Cleaner
Owner's Manual
Hayward Pool Products
620 Division Street, Elizabeth, NJ 07201 USA
908.351.5400 • www.hayward.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ABOVE GROUND Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Hayward ABOVE GROUND Series

  • Page 1 ISM926 Rev. A ABOVE GROUND SERIES Suction Pool Cleaner Owner’s Manual Hayward Pool Products 620 Division Street, Elizabeth, NJ 07201 USA 908.351.5400 • www.hayward.com...
  • Page 2: Safety Warnings

    Store the cleaner in a shaded, safe area. Hayward turbine cleaners are powered by your pool’s filter system and are Hoses must be stored straight. DO NOT coil the hose. designed to work well with most systems. The performance of the cleaner in your pool will be relative to its power source.
  • Page 3: Carton Contents

    CARTON CONTENTS PREPARING THE POOL Please complete the following steps to prepare your pool for installation: DEBRIS Remove any large objects and excessive debris from the pool. WATER LEVEL Confirm that water level is at the recommended level. Pool Cleaner Connector WATER CHEMISTRY Make sure water is properly...
  • Page 4: Installation

    INSTALLATION Step 2 Pull hose to farthest location in the pool opposite the wall connector or Sizing Suction Hose skimmer + 2 extra hose sections. Step 1 Connect hose sections. Note: Make sure all connections are tight to prevent air leaks. TIP: Wetting the hose ends will make it easier to connect the hose sections.
  • Page 5 • Hayward regulator valve Note: Hose end goes into cone adapter. To install the Hayward regulator valve: Remove the hose from the skimmer cone adapter. Close the regulator valve by rotating the blue collar clockwise until tight.
  • Page 6 The regulator valve cannot be used to INCREASE the initial vacuum reading. View our YouTube video at www.youtube.com/watch?v=aqyrv_9nJZI or contact your authorized Hayward Dealer for assistance. Step 6 Submerge the cleaner into the water to remove all air. Step 8...
  • Page 7: Important Tips

    Coiled hoses are not covered under the Hayward warranty. Adjust the water return toward the center of the pool so water circulation does not interfere with the cleaner’s pool coverage capability. Use only original Hayward spare parts and hoses to ensure proper operation.
  • Page 8: Maintenance Tips

    Check the condition of the “shoes, wings, and flaps” periodically. Step 1 WEAR MARK GOOD SHOE WORN SHOE Step 2 WEAR LINE Hayward is not responsible for damage caused by misuse of the cleaner or damage caused by worn or broken parts.
  • Page 9 MAINTENANCE TIPS Wing Replacement: Step 3 Step 1 Step 4 Step 2...
  • Page 10: Troubleshooting

    TROUBLESHOOTING FOR TECHNICAL ASSISTANCE, CALL: 908.355.7995 PROBLEM CAUSES SOLUTION PROBLEM CAUSES SOLUTION Lack of/improper water Check water flow with flow Improper water flow Check water flow with flow flow through cleaner gauge and adjust as per gauge and adjust as per Step 5.
  • Page 11: Warranty

    Pool Products with respect to its pool products and is in lieu of all other Model Number ____________________________ warranties expressed or implied, including warranties of merchantability or Type of Pool: fitness for a particular purpose. In no event shall Hayward Pool Products be Concrete/Gunite Vinyl Fiberglass Pool Capacity _________________ (U.S.
  • Page 13 Hayward Pool Products 620 Division Street, Elizabeth, NJ 07201 USA 908.351.5400 • www.hayward.com...
  • Page 14 IS101HET Rev. A...
  • Page 15 ABOVE GROUND SUCTION CLEANER Penguin Model...

This manual is also suitable for:

Penguin automatic cleaner

Table of Contents