DCS DishDrawer DD124P5 Use And Care Manual page 29

Fault Codes
F1
F2
F3
F4
F5
F6
F7
F8
F9
Possible Causes
Flood switch has been
activated.
Motor problem.
Temperature sensor
failed.
Faulty temperature
sensor or element
Lid fault
Lid fault
Lid fault
Electrical problem
Electronics
malfunction.
Fault codes
What to Do
Turn the water and power supply to the
DishDrawer® off and call your Authorized
Service Center.
Call your Authorized Service Center.
Ensure water coming in through the inlet
o
hose is less than 149 F. You may need to
install a tempering valve on your water
supply.
Call your Authorized Service Center.
Turn power supply to DishDrawer off,
1
then turn on power supply. Fault may
reset.
Call your Authorized Service Center.
2
Turn power supply to DishDrawer off,
1
then turn on power supply. Fault may
reset.
Call your Authorized Service Center.
2
Call your Authorized Service Center.
Turn power supply to DishDrawer off.
1
Call your Authorized Service Center.
2
Call your Authorized Service Center.
27
US CA