DCS DishDrawer DD124P5 Use And Care Manual page 27

Problem
Continuous
beeping
Intermittent
beeping
DishDrawer® will
not start
Excess water in the
DishDrawer®
Water marks on the
dishes
DishDrawer®
interior is stained
Dishes did not dry
No detergent
dispensed
Excessive motor
noise
Possible Cause
A fault has occurred.
DishDrawer® is in pause
mode.
Power supply is not
connected.
The drawer is not closed
properly.
Lock feature is on.
button not pressed.
Drain hose(s) bent or
kinked.
Blocked filters.
Rinse agent depleted.
Rinse agent setting too low. Increase the rinse agent setting.
DishDrawer® overloaded/
incorrectly loaded.
Some foods, like tomato
based products, may
stain the inside of the
DishDrawer®.
Incorrect loading.
Rinse agent depleted.
Rinse agent setting too low. Increase the rinse agent setting.
Eco wash program used.
Detergent dispenser was
wet when loaded.
The filter plate and/or spray
arm is incorrectly placed.
No water in the motor area.
Troubleshooting
What to do
Refer to the Fault codes section.
Close the DishDrawer® and press the
button.
Connect the power supply.
Ensure the drawer is firmly closed.
Turn Lock off. Hold down the
the light above the
Press the button.
Straighten the drain hose(s).
Clean the filter plate/drain filter. Refer to the
Care and cleaning section.
Refill the rinse agent dispenser.
Refer to the section on loading.
Pre-rinse dishes before placing in the
DishDrawer®. Alternatively, using the Rinse
program after adding the dishes may
minimize staining.
Ensure the dishes are not nesting together.
Refill the rinse agent dispenser.
Choose a standard wash program.
Clean the dispenser and ensure the
dispenser is dry when adding detergent.
Refer to the care and cleaning section for
details on correct placement.
This usually occurs on the first use or when
the DishDrawer® has not been used for
long periods of time. Run the DishDrawer®
through a wash program.
25
button until
button disappears.
US CA