Removing The Tub; Installation Instructions - DCS DD124-C Installation Instructions Manual

INSTALLATION INSTRUCTIONS

PLEASE NOTE: Your model of DishDrawer
installation diagrams. Installation is similar for all models for either Single or Double models.
Information referring to Single models only is highlighted in blue.
been simplified to enable clearer instruction.
STEP 1:
MOVING THE PRODUCT INTO THE CAVITY
2
WARNING!
Be careful of
sharp edges.
STEP 2:

REMOVING THE TUB

5
7
6
9
may differ from the model shown in the
®
1
3
4
Important!
DO NOT push
middle of drawer(s).
8
Installation diagrams have
MOUNTING TAB OPTIONS
The mounting tabs are in pairs, one on each side of the product. They are
used to secure the product to the cavity sides. Installation requires two
sets of tab pairs be used. DOUBLE MODELS ONLY -
OR B and C tab pairs may be used. All tabs would be optimum.
1
If the top installation tabs
inserting into the top slots as shown. Ensure the tabs are fully
locked in place.
2
Optional Flexible Extrusion
If the cavity is 24" x 34
can be attached along the top and sides of the product. Open the
drawer(s) to expose the chassis trim. Remove extrusion backing
and adhere to the side and top of DishDrawer®. Refer to the
drawing for correct placement.
Be sure that extrusions do not prevent the drawer from closing
completely.
3
Check cavity for any obstructions that may interfere with sliding
the product back. DOUBLE MODELS ONLY - loosen the feet first.
4
Push product into cavity to suit adjacent cabinetry. Do not push
middle of drawer(s). Be sure inlet, drain hose(s) and power supply
cord are not restricted or damaged by carefully pulling all excess
length through the services hole, while the product is being pushed
back into the cavity.
FOR SINGLE MODELS, check that the base of the product is not
bowed. Do not rest single models on your knee when moving them
into the cavity.
Important!
(SINGLE MODELS ONLY).
The product may move. Mark chassis position on cavity.
5
SINGLE MODELS ONLY. Gently open the drawer and mark the
chassis position on the cavity, before removing the tub.
6
Open the drawer (bottom drawer in DOUBLE MODELS). Release
the tub by depressing the right hand tub clip and pushing it back
1 3 / " (30mm). Repeat on the left hand side.
16
7
Lift the tub up off the drawer runners.
8
Slide both runners back into the product.
9
Place the tub onto the floor.
For SINGLE MODELS, depending on the height of the cavity, the tub
will need to be supported, eg on a chair.
READ THESE INSTRUCTIONS
COMPLETELY AND CAREFULLY.
A and
C are to be used, fit to the chassis by
1
/ " (610mm x 876mm) flexible extrusions
2
R
B tab pairs
7