Appendix: Telnet Interface Administration; Setting An Ip Address Without Ps Admin - D-Link PS Admin User Manual

Appendix: Telnet Interface Administration

This appendix describes the use the
controlling and configuring D-Link network print servers.

Setting an IP Address without PS Admin

The PS Admin program allows you to set your print server's IP
address (and other TCP/IP parameters). If you don't have a
Windows-based workstation and you need to set your print server's
address, you can use a BOOTP (Boot Protocol) server, or the
manual method described below.
If you want to use BOOTP, your local Ethernet network needs to
have a BOOTP server. The BOOTP server table needs to have an
entry listing the print server's Ethernet (MAC) address, the IP
address you want to assign to the print server, the network's mask,
and the default gateway (router) address. Consult your BOOTP
server documentation for information about how to add an entry to
the server table.
If you aren't using BOOTP, you can manually set the IP address
using the following method:
1. Note your print server's Ethernet (MAC) address. The
Ethernet address is a 12-digit hex number printed on a sticker
the bottom of your print server.
2. Use a host on the same local Ethernet network as the print
server. Change your host's ARP (address resolution
Appendix: Telnet Interface Administration
Print Server Administration User's Guide
interface for
telnet
111