D-Link AirPremier DWL-2210AP Manual page 55

Setting the Ethernet (Wired) Interface
Field
Static IP Address
enabled.
Subnet Mask
Default Gateway
DNS Nameservers
Configuring Guest Interface Ethernet Settings
To configure Ethernet settings for the "Guest" interface, fill in the fields as described
below.
Field
Field Description
MAC Address
VLAN ID
Updating Settings
To apply your changes, click Update.
Description
If you chose "Static IP" as the Connection Type, these fields will be
Enter the Static IP Address in the text boxes.
Subnet Mask
Enter the
information from your ISP or network administrator.
Default Gateway
Enter the
The Domain Name Service (DNS) is a system that resolves the
descriptive name (domain name) of a network resource (for
example, www.dlink.com) to its numeric IP address (for
example, 66.93.138.219). A DNS server is called a Nameserver.
There are usually two Nameservers; a Primary Nameserver and
a Secondary Nameserver.
Dynamic
You can choose
• If you choose Manual, you should assign static IP addresses
manually.
• If you choose Dynamic, the IP addresses for the DNS servers
will be assigned automatically via DHCP. (This option is only
available if you specified DHCP for the Connection Type.)
Field Description
Description
Shows the MAC address for the Guest interface for the Ethernet
port on this access point. This is a read-only field that you
cannot change.
If you enable Guest access and configure Internal and Guest
networks by "VLANs", this field will be enabled.
Provide a number between 1 and 4094 for the Guest VLAN.
in the text boxes. You must obtain this
in the text boxes.
Manual
or mode.
55