D-Link AirPremier DWL-2210AP Manual page 151

Appendix A: Configuring Security Settings on Wireless Clients
1. Configure the following settings on the Association tab on the Network Properties
dialog.
Association Tab
Network Authentication
Data Encryption
2. Configure these settings on the Authentication tab.
Authentication Tab
Enable IEEE 802.1x
authentication for this network
EAP Type
3. Click Properties to bring up the Smart Card or other Certificate Properties dialog and
enable the "Validate server certificate" option.
Smart Card or other Certificate Properties Dialog
Validate Server Certificate
Certificates
Click OK on all dialogs to close and save your changes.
4.To complete the client configuration you must now obtain a certificate from the RADIUS
server and install it on this client. For information on how to do this see "Obtaining a
TLS-EAP Certificate for a Client" in this manual.
Logging on to the Wireless Network with a WPA Client Using a Certificate
WPA clients should now be able to connect to the access point using their TLS
certificates. The certificate you installed is used when you connect, so you will not be
prompted for login information. The certificate is automatically sent to the RADIUS
server for authentication and authorization.
WPA
TKIP or AES depending on how this option is configured
on the access point.
Note: When the Cipher Suite on the access point is set
to "Both", then TKIP clients with a valid TKIP key and
AES clients with a valid CCMP (AES) key can associate
with the access point. For more information, see
Administrators Guide and Online Help on the access
point.
Enable (click to check) this option.
Choose Smart Card or other Certificate.
Enable this option (click to check the box).
In the certificate list shown, select the certificate for this
client.
151