Advertisement
PUSH POP-UP INSTALLATION
Remove the drain plug and gasket from push pop-up assembly.
1
remove the washer, lock nut and un-thread bottom drain tube.
Insert flange on the drain hole up through bottom of lavatory.
2
add silicon sealant/putty around the flange. Secure by adding
rubber washer, gasket, plastic washer and lock nut.
Insert the threaded end of the assembly up from the under the sink
3
so that the drain tube is firmly attached to the drain plug..
Make sure to add plumber tape before threading the drain tube.
Make sure the thread of drain flange and bottom of the drain tube are tighten.
4
If not it may cause water leaks. add tape or tighten the locknut from
under the sink.
5
Test the push pop-up for smooth operation. to open push pop-
up simply push once. Push again to close it.
The measurements shown are for reference only. Products and specifications shown are subject to change without notice.
www.santecfaucet.com | P: 310.542.0063 F: 310.542.5681
3/7
Advertisement
