Table of Contents
Advertisement
Steam
en
Prove dough
Dough will prove considerably more quickly using the
"Dough proving
" type of heating than at room
R
temperature and does not dry out.
Use the information in the tables to select the
appropriate setting. ~ "Tested for you in our cooking
studio" on page 40
If the water tank runs dry during the operation
Note:
with the Dough proving setting, the operation is
interrupted. Fill the water tank.
Starting
Fill the water tank.
1.
Only switch on Dough proving once the
Note:
cooking compartment has completely cooled down
(to room temperature).
Touch the Menu button.
2.
Touch the "Steaming" field.
3.
Use the rotary selector to set to "Dough proving
4.
Touch the "Temperature" field and set the
5.
temperature using the rotary selector.
Touch the "Duration" field and set the duration using
6.
the rotary selector.
Press the Start/Stop button to start.
7.
The appliance heats up.
A signal sounds. The oven stops heating. You can
cancel the audible signal early using the
Cancelling
Touch the Start/Stop button to cancel the operation.
Finishing
Touch the On/Off button to switch off the appliance.
Filling the water tank
The water tank is located behind the control panel.
Before starting an operation with steam, open the
control panel and fill the water tank with water.
Make sure that you have set the water hardness range
correctly. ~ "Basic settings" on page 20
:
Warning – Risk of injury and risk of fire!
Only fill the water tank with water or with the descaling
solution that is recommended by us. Do not pour any
flammable liquids (e.g. alcoholic drinks) into the water
tank. Due to hot surfaces, vapours from flammable
liquids may catch fire in the cooking compartment
(explosion). The appliance door may spring open. Hot
steam and jets of flame may escape.
:
Warning – Risk of burns!
The water tank may heat up while the appliance is in
operation. Wait until the water tank has cooled down
after the previous appliance operation. Remove the
water tank from the water tank recess.
Caution!
The appliance may become damaged due to the use of
unsuitable liquids.
Do not use distilled water, highly chlorinated tap water
(> 40 mg/l) or other liquids.
24
Only use cold, fresh tap water, softened water or
uncarbonated mineral water.
Caution!
Malfunctions may occur when using filtered or
demineralised water.
The appliance may request that you top up the water
tank even though it may be full, or operation with steam
is cancelled after approx. two minutes.
If required, mix filtered or demineralised water with the
bottled non-carbonated mineral water with a ratio of
one to one.
Notes
■
■
■
■
".
R
1.
2.
3.
button.
0
4.
5.
6.
If your water is very hard, we recommend that you
use softened water.
If you use only softened water, you can set your
appliance to the "softened" water hardness range.
If you use mineral water, set the water hardness
range to "4 very hard".
If you use mineral water, you must only use non-
carbonated mineral water.
Touch the
X
field.
The control panel is pushed forwards automatically.
Pull the control panel forwards with both hands and
then push it upwards until it locks into place (Fig.
Lift the water tank and remove it from the water tank
recess (Fig.
).
"
Press down on the cover along the seal to prevent
water from leaking out of the water tank.
Take out the cover
(Fig.
‚
Whether or not there is a cover
Note:
the appliance type.
Fill the water tank with cold water up to the "max."
mark (Fig.
).
$
!
).
#
depends on
‚
).
Advertisement
Table of Contents
