Exploitation; Fig.4 Removing The Wooden Platform; Fig.5 Control Panel - Igloo Wojtek 1.0 W User Manual

Fig.4 Removing the wooden platform

1 – Unscrew the feet from the platform
2 – Remove the wooden platform
3 – Screw the feet in nuts welded to the frame of the device

4. EXPLOITATION

Temperature of the cooled space and aggregate operating cycle may fluctuate. They depend on numerous factors,
such as amount and temperature of products placed in the device and temperature of the surroundings.
The device should be placed in a dry and well-ventilated place, ensuring proper air exchange (distance between the
wall and the device – min. 10 cm), out of sunlight, kept far from heat sources and devices enforcing air flow (ceiling
and portable ventilators, blow-in heaters). The device functions properly in a room, where temperature falls within
appropriate climatic class stated on the data plate. The operation of the device may worsen when it shall operate in
temperature lower or higher than the stated temperature range.
Remarks and indications
• It is necessary to properly level the display cabinet, which will prevent loud operation of the device and
shall ensure proper water (condensate) outflow during defrosting.
• After transporting the device, wait about 2 hours before its actuation.
• The first filling of cooling space should be performed after its previous cooling to working temperature.
This principle should also be observed after longer pause in exploitation.
• Do not block any ventilation holes, which would hamper circulation of the cooled air. It is also necessary
to ensure proper airflow around the device (aggregate ventilation holes cannot be covered!!!!).
• Keep the condenser clean. Impurities may lead to overheating of the compressor and as a consequence
may result in damage of the device, which is not covered by warranty.
• Do not use electric devices inside grocery product storing chamber.
• In case when the device is being exploited without the need to display goods (night work; closed stand,
cake shop) it is necessary to roll down the roller in the cabinet in order to decrease electric energy
consumption!
13
User manual WOJTEK

Fig.5 Control panel

1 – Thermostat (temperature regulator) panel
(service details in Chapter No. 7 p.17 and 18)
2 – Lighting (lamp) switch
3 – Main switch (turns on/off the aggregate of the device)
en
www.igloo.pl