Advertisement
3 to 6 months
1.Open vise to maximum opening.
2.Loosen and remove the movable jaw.
3.Remove spiral-retaining ring from handle end of the vise
screw.
4.Remove the screw support from the vise body.
5.Remove the two-piece locking collar by removing the four
SHCS.
6.With one screw still half way out spin off the first collar.
7.Using a pin or screw reach into the second collar and spin it
off exposing the bearings.
8.Remove the thrust bearing assembly consisting of (2) thrust
washers and (1) thrust bearing from the counter bore
in the end of the body.
9.Clean and inspect the counter bore, thrust washers and
thrust bearing.
10.Apply water resistant grease to the thrust washer (i.e. marine
grade grease)
11.Install thrust bearing assembly on the screw in the reverse
manner.
12.Install the first collar by spinning on the screw until it
stops. (Items 12-14—See Fig. 1)
13.0Install the second collar behind the first and spin on until
it stops. At this point the screw holes may or may not
be lined up.
14.Turn the second collar counterclockwise until a hole lines
up.
14
ENGLISH |
Advertisement
