Table of Contents
Advertisement
GTRM40
Before working with the appliance
Persons using the appliance must not be under the influence of intoxicants, alcohol,
medication, etc.
Before you begin work, make that you are familiar with all attachments and operating
controls as well as their functions.
Only use connection cables in the open that have been authorized for this purpose and are
correspondingly marked, e.g.H07RNF2 1.5mm2(max.50m).connection parts of connection
cables must be splash-proof and coated with rubber.
Before using the mower, always check that the connection cable is not damaged, cracked or
tangled. To do this switch off the unit and pull out the mains plug. Do not use a damaged
connection cable.
Before using the appliance:
Check whether the grass catcher works and the ejection flap closes correctly damaged, worn
or missing parts must be replaced immediately
Check for any wearing or damage to the cutters, fastening pins and the whole cutter unit; all
worn or damaged parts must be replaced in sets at a specialist workshop in order to rule out
imbalances.
Check whether the cable between the motor and switch/connection combination is damaged.
Damaged cables must be replaced at a specialist workshop immediately.
Spare parts must fulfill the requirements laid down by the manufacturer. You should only use
original spare parts or those which have been approved by the manufacturer.
All repair work must be conducted exclusively by a qualified technician.
When working with the appliance
When working with or on the appliance you must wear protective clothing.
This includes:
Safety shoes
Trousers
Close-fitting garments
Protective goggles, etc.
Operate the mower only when it is in good working condition as stipulated and delivered by
the manufacturer.
Before all work on this appliance
Avoid injuries by observing the following. Before carrying out any work on the machine:
Switch OFF the motor.
Wait until all moving parts have come to a complete standstill.
Remove the mains plug.
After working with the appliance
Before you leave the lawnmower unattended always remove the mains plug.
Danger!
Never use a lawnmower if it has damaged safety devices or if there are no safety devices fitted.
Operating safety
Danger!
Electric shock
For safety reasons, the socket used to power the mower should be backed up by
residual-current-device (RCD) which can be tripped by a max. Current of 30mA.
If you happen to cut through the cable when mowing, there is danger to life or risk of injury.
WWW.COBRAGARDEN.CO.UK
Original Instruction Manual
8
Advertisement
Table of Contents
